Before installing LED tubes:

• Disconnect power to the light fixture to be used.
• Remove all ballasts and starter (if applicable).
• Secure power cord into the fixture with a listed connector.
• Connect ground wire to fixture casing using a 10/32 ground screw or ground clip.
• Connect one line lead to a socket at one end of the fixture.
• Connect the other line wire or neutral wire to the socket at the other end of the fixture.
• Connections can be made to either socket connection points.  (the tube pins are connected together)
• Never connect two wires of different potential to the same socket!  (this will cause a short circuit)
• Maximum smoke, minimum efficiency is never a good thing.
• For multiple tubes, jumper from socket to socket on the same end of the fixture.